欧美极品高清xxxxhd,国产日产欧美最新,无码AV国产东京热AV无码,国产精品人与动性XXX,国产传媒亚洲综合一区二区,四库影院永久国产精品,毛片免费免费高清视频,福利所导航夜趣136

標題: 發現M16的TC1的重大缺陷！！！！！ [打印本頁]

作者: dianz1024 時間: 2012-7-25 22:56
標題: 發現M16的TC1的重大缺陷！！！！！
發現M16的TC1的重大缺陷！！！！！本人用M16的TC1產生PWM信號，并且在產生信號的同時不斷改變頻率，但變頻幅度很小，這時就出現一個很令人費解的現象，PWM信號會不時有斷開的現象 PWM頻率：28KHz OC1A、OC1B雙路輸出：想得到的信號是：如圖正常的波形但是一旦改變頻率，兩路的信號會隨即的中斷6.5ms左右,如圖斷開的波形，不知其解，各位高手請指教程序： // Target : M16 // Crystal: 10.000Mhz #include #include void port_init(void) { PORTA = 0x00; DDRA = 0x00; PORTB = 0x00; DDRB = 0x00; PORTC = 0x00; //m103 output only DDRC = 0x00; PORTD = 0x00; DDRD = 0b00110000; } //TIMER1 initialize - prescale:1 // WGM: 8) PWM phz freq correct, TOP=ICRn // desired value: 28KHz // actual value: 28.090KHz (0.3%) void timer1_init(void) { TCCR1B = 0x00; //stop TCNT1H = 0xFF; //setup TCNT1L = 0x4E; OCR1AH = 0x00; OCR1AL = 0xB2-0x50; OCR1BH = 0x00; OCR1BL = 0x50; ICR1H = 0x00; ICR1L = 0xB2; TCCR1A = 0xB0; TCCR1B = 0x11; //start Timer } //call this routine to initialize all peripherals void init_devices(void) { //stop errant interrupts until set up CLI(); //disable all interrupts port_init(); timer1_init(); MCUCR = 0x00; GICR = 0x00; TIMSK = 0x00; //timer interrupt sources SEI(); //re-enable interrupts //all peripherals are now initialized } void Delay(unsigned int t) { unsigned int i,j; for(i=0;i9)i=0; Delay(100); //延時 ICR1L=ICR1L_+i; //改變頻率 } }

歡迎光臨 (http://m.raoushi.com/bbs/)